Welcome, Guest. Please login or register.

Login with username, password and session length
 

News:

Welcome to the first online community for VFD experts
More Interesting sections are hidden from Guests
Go for registration to open your sight to the entire site ;)

*


Recent Posts

Pages: 1 [2] 3 4 ... 7
11
General Discussion / Re: Single Phase Motor
« Last post by SubartNajm on September 22, 2019, 03:57:02 PM »
I found the following article from Schneider Electric, they say the following SS is applicable for 1PH motors

https://www.schneider-electric.com/en/faqs/FA164706/
12
Other/General Applications / Re: conveyor motor control by VFD
« Last post by KgSwat on September 19, 2019, 02:10:20 PM »
thanks for reply. do you suggest a certain good quality brand from your experience?
13
General Discussion / VFD Output
« Last post by SubartNajm on September 19, 2019, 02:05:30 PM »
Good day

I wonder if someone can suggest a Multimeter hat an read accurately the inverter output (V/A), I tried to read in a multimeter, but it showed rapid readings  :49: .
14
General Discussion / Single Phase Motor
« Last post by Ahmadjo on September 19, 2019, 09:49:37 AM »
Hi
i found a topic talking about running a single phase motor through vfds, but my question here is if we can run a single phase motor by a three phase softstarter ?

does any body know, please answer
15
Yaskawa / Inverter Selection for Blower
« Last post by KgSwat on September 16, 2019, 10:58:12 AM »
Hello Guys  :048:

I am confused what is the least model should I select for a Powder Blower, the motor is 7.5kW @ 380V.
Please find attached table.
 :023:
16
CG/Emotron / Re: FDU Inverter Fault (PFComm Err)
« Last post by AbdulAziz19 on September 16, 2019, 08:43:03 AM »
Than you for your reply.

I checked that "flat cable", I disconnected it and reconnected it, it worked few minutes then same problem happened  :029: :50:
I will try o change it. thank you again
17
CG/Emotron / Re: FDU Inverter Fault (PFComm Err)
« Last post by أحمد علي بك on September 14, 2019, 11:09:48 PM »
Hi,

Check the flatcable between power & control board, there must be a loose.

Good luck  :045:
18
CG/Emotron / FDU Inverter Fault (PFComm Err)
« Last post by AbdulAziz19 on September 10, 2019, 09:40:02 AM »
Dear Community

I am facing a problem with the FDU inverter, it is showing the following fault: "PFComm Err"

Could someone help ?
19
General Discussion / Re: Nice YASKAWA Robot Sword :)
« Last post by KgSwat on August 31, 2019, 10:52:56 PM »
Wow .. I like its moves  :045:
20
Mitsubishi / Re: FR-F800 not running!
« Last post by KgSwat on August 31, 2019, 10:46:50 PM »
Lol  :62: :62: :62:

After frequent test, I noticed that what you said was accurately what happened. However, having the USB cable connected to the configurator software was the reason, I did same paramters changes, but the cable was still connected.

thank you Eng_Mq  :54:
Pages: 1 [2] 3 4 ... 7
*